Netgear FS728TPv1 FS728TP Hardware manual - Page 11

meters over Category 5 Unshielded Twisted-Pair UTP cable, but much longer for fiber

Get Netgear FS728TPv1 - ProSafe 24 Port 10/100 Smart Switch PDF manuals and user guides View all Netgear FS728TPv1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

FS728TP Hardware Installation Guide Service (CoS) for traffic prioritization. These features provide better understanding and control of the network. Initial discovery of the switch on the network requires the SmartWizard Discovery program, a utility that runs on a PC. The FS728TP Smart Switch can be free-standing, or rack mounted in a wiring closet or equipment room. It is IEEE-compliant and offers low latency for high-speed networking. All ports can automatically negotiate to the highest speed. This capability makes the switch ideal for environments that have a mix of Ethernet, Fast Ethernet, or Gigabit Ethernet devices. In addition, all RJ-45 ports operate in half- or full-duplex mode. The maximum segment length is 328 feet (100 meters) over Category 5 Unshielded Twisted-Pair (UTP) cable, but much longer for fiber connections using SFP GBIC modules. The NETGEAR Smart Switch can be used as a desktop to build a small network that enables you to have 1000 Mbps access to a file server. With full-duplex enabled, the switch port connected to the server or PC can provide 2000 Mbps throughput. Figure 1-1 Introduction v1.0, November 2007 1-14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
FS728TP Hardware Installation Guide
Introduction
1-14
v1.0, November 2007
Service (CoS) for traffic prioritization. These features provide better understanding and control of
the network. Initial discovery of the switch on the network requires the SmartWizard Discovery
program, a utility that runs on a PC.
The
FS728TP Smart Switch
can be free-standing, or rack mounted in a wiring closet or equipment
room. It is IEEE-compliant and offers low latency for high-speed networking. All ports can
automatically negotiate to the highest speed. This capability makes the switch ideal for
environments that have a mix of Ethernet, Fast Ethernet, or Gigabit Ethernet devices. In addition,
all RJ-45 ports operate in half- or full-duplex mode. The maximum segment length is 328 feet (100
meters) over Category 5 Unshielded Twisted-Pair (UTP) cable, but much longer for fiber
connections using SFP GBIC modules.
The NETGEAR Smart Switch can be used as a desktop to build a small network that enables you
to have 1000 Mbps access to a file server. With full-duplex enabled, the switch port connected to
the server or PC can provide 2000 Mbps throughput.
Figure 1-1