Netgear FSM7352PS FSM7352S Hardware manual - Page 28
Command Line Interface Reference for the ProSafe 7300S Series Layer-3 - user manual
UPC - 606449043457
View all Netgear FSM7352PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Hardware Installation Guide for Managed Stackable Layer 3 Fast Ethernet Switches Console port on rear panel Figure 3-5 2. Connect the other end of the cable to a workstation or terminal. 3. If you attached a workstation, start a terminal-emulation program. • Microsoft Windows users can use HyperTerminal, which comes with the Windows operating systems. • Macintosh users can use ZTerm. • UNIX users can use a terminal emulator such as TIP. 4. Configure the terminal-emulation program to use the following settings: • Baud rate: 9,600 bps • Data bits: 8 • Parity: none • Stop bit: 1 • Flow control: none After you connect a console to the switch, you will need to configure the switch. The following documents are provided for this purpose: • Quick Install Guide: Explains basic set up and configuration (provided as both a print document and in PDF format on the NETGEAR CD) • Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches: Gives detailed examples of how to use the CLI, and is located on the NETGEAR CD. • Administration Manual for the ProSafe 7300S Series Layer-3 Stackable Switches: Describes configuration tasks, and is located on the NETGEAR CD. 3-10 v1.0, March 2006 Hardware Installation