Netgear GS108 User Guide - Page 6

3 Install the Switch and Connect the Other Devices Apple G4 PC with GA302T Adapter 10/100/1000 Mbps Gigabit Switch GS108 10M: On=Link, Blink=Act 1 2 3 4 5 6 7 8 Pwr Green=FDX, Yellow=Collision 1000M 100M 1 2 3 4 5 6 GS108 8-Port 10/100/1000 Mbps Gigabit Ethernet Switch On=Link, Blink=Act 7 8 Server with GA622T Adapter DSL modem LOCAL 10/100M 8 7 6 5 4 3 2 1 INTERNET 12VDC 1.2A OFF ON FVS318 Cable/DSL ProSafe VPN Firewall 1. Place the switch on a flat surface or hook onto the screws. 2. For each device, insert one end of an Ethernet cable into the port in the device and insert the other end into one of the Ethernet ports on the switch. 3. Connect the power adapter's cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip). The Power light should light up. Link, Act, FDX, Power Collision LED 1000M 100M LED LED The corresponding 10/100/1000 Mbps Gigabit Switch GS108 10M: On=Link, Blink=Act 1 2 3 4 5 6 7 8 1000M 100M On=Link, Blink=Act Link LED for each Pwr Green=FDX, Yellow=Collision 1 2 3 4 5 6 7 8 connected and Model GS108 8-Port 10/100/1000 Mbps Gigabit Ethernet Switch powered device should light and flash when activity occurs. If the connection is 1,000 Mbps or 100 Mbps, the LED in the RJ-45 jack will light up. If the connection is 10 Mbps, the 10M LED on the left side of the front panel will light up. Note: If any light doesn't operate as indicated, go to the Troubleshooting section.