Netgear GS752TPSB GS7xxTS-TPS Hardware Installation Guide - Page 17
LED Designations, RJ-45 Port LEDs
View all Netgear GS752TPSB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide Figure 9. GS752TPS Back Panel The back panel contains a power connector. LED Designations Power Connector RJ-45 Port LEDs The following table describes the RJ-45 port LED designations. There is one LED for each RJ-45 port. LED Designation Ethernet Mode: SPD/Link/ACT LED • Off- No link established. • Solid Green - A valid 1000 Mbps link is established. • Blinking Green - The port is transmitting or receiving packets at 1000 Mbps. • Solid Yellow - A valid 10/100 Mbps link is established. • Blinking Yellow - The port is transmitting or receiving packets at 10/100 Mbps. PoE Mode: PoE Status LED • Off - No PoE powered device (PD) is connected. • Solid Green -The PoE powered device (PD) is connected and the port is supplying power successfully. • Solid Yellow - Indicates one of the following failures resulted in stopping power to that port: - Short circuit on the PoE power circuit. - PoE power demand exceeds the power available. - PoE current exceeds the PD's classification. - Out of proper voltage band (44 ~ 57 VDC for af, 50~57 VDC for at). Note: If the port media is changed to fiber, the Ethernet LED will change to the OFF status. Chapter 2. Physical Description | 17