Netgear GSM7328FS-100NAS FSM7328PS Command line reference manual - Page 381
Configuration Scripting Commands
View all Netgear GSM7328FS-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 381 highlights
Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches, 18.5 Configuration Scripting Commands Configuration Scripting allows you to generate text-formatted script files representing the current configuration of a system. You can upload these configuration script files to a PC or UNIX system and edit them. Then, you can download the edited files to the system and apply the new configuration. You can apply configuration scripts to one or more switches with no or minor modifications. Use the show running-config command (see Section 18.1.9 "show running-config" on page 18-16) to capture the running configuration into a script. Use the copy command (see Section 18.2.10 "copy" on page 18-20) to transfer the configuration script to or from the switch. You should use scripts on systems with default configuration; however, you are not prevented from applying scripts on systems with non-default configurations. Scripts must conform to the following rules: • Script files are not distributed across the stack, and only live in the unit that is the master unit at the time of the file download. • The file extension must be ".scr". • A maximum of ten scripts are allowed on the switch. • The combined size of all script files on the switch shall not exceed 2048 KB. • The maximum number of configuration file command lines is 2000. You can type single-line annotations at the command prompt to use when you write test or configuration scripts to improve script readability. The exclamation point (!) character flags the beginning of a comment. The comment flag character can begin a word anywhere on the command line, and all input following this character is ignored. Any command line that begins with the "!" character is recognized as a comment line and ignored by the parser. The following lines show an example of a script: ! Script file for displaying the ip interface ! Display information about interfaces show ip interface 1/0/1 !Displays the information about the first interface ! Display information about the next interface show ip interface 1/0/2 ! End of the script file System Maintenance Commands v3.0, January 2008 18-29