Netgear GSM7328S GSM7352S Hardware manual - Page 26
Connecting a Redundant Power Supply, Connecting Equipment to the Switch, RJ-45 Ports
UPC - 606449067972
View all Netgear GSM7328S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Managed Stackable Layer 3 Switches GSM7328S and GSM7352S Hardware Installation Guide Connecting a Redundant Power Supply Each switch has a redundant power supply (RPS) connector at the rear of the switch next to the power receptacle. Power receptacle Redundant power supply connector Figure 3-6 You can connect an external DC-to-DC power supply unit to the switch to provide redundant power in case the primary power supply fails. To connect a redundant power supply (RPS) unit to the switch, first turn off the switch. When the power is off, you can remove the cover plate and connect the RPS unit to the switch. After all connections are completed, apply power to the switch. Connecting Equipment to the Switch You can connect devices, a Gigabit Ethernet module, and/or a console to the switch. RJ-45 Ports The switch uses Auto Uplink technology, which enables you to attach devices using either straight-through or crossover cables. Use a Category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector. Note: Ethernet specifications limit the cable length between the switch and the attached device to 328 feet (100 meters). 3-10 v1.0, March 2006 Hardware Installation