Netgear M5300-28GF3 Command Line Interface (CLI) User Manual - Page 736
QoS
![]() |
View all Netgear M5300-28GF3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 736 highlights
ProSafe Managed Switch Table 35. Protocol-based VLANs Log Messages Component Message Cause Protocol Based VLANs pbVlanCnfgrInitPhase2Process: Unable to register NIM callback Appears when nimRegisterIntfChange fails to register pbVlan for link state changes. Protocol Based pbVlanCnfgrInitPhase2Process: Unable to Appears when vlanRegisterForChange VLANs register pbVlan callback with vlans fails to register pbVlan for vlan changes. Protocol Based pbVlanCnfgrInitPhase2Process: Unable to Appears when nvStoreRegister fails to VLANs register pbVlan callback with nvStore register save and restore functions for configuration save. QoS Table 36. ACL Log Messages Component ACL ACL ACL ACL Message Cause Total number of ACL rules (x) exceeds max The combination of all ACLs applied to an (y) on intf i. interface has resulted in requiring more rules than the platform supports. ACL name, rule x: This rule is not being logged The ACL configuration has resulted in a requirement for more logging rules than the platform supports. The specified rule is functioning normally except for the logging action. aclLogTask: error logging ACL rule trap for The system was unable to send an SNMP correlator number trap for this ACL rule which contains a logging attribute. IP ACL number: Forced truncation of one or more rules during config migration While processing the saved configuration, the system encountered an ACL with more rules than is supported by the current version. This may happen when code is updated to a version supporting fewer rules per ACL than the previous version. Table 37. CoS Log Message Component COS Message Cause cosCnfgrInitPhase3Process: Unable to The COS component was unable to apply apply saved config -- using factory defaults the saved configuration and has initialized to the factory default settings. Log Messages 736
![](/manual_guide/products/netgear-m530028g-command-line-interface-cli-user-manual-498f108/736.png)