Netgear RND4410v2 Hardware Manual - Page 8
Diskless Units, To prepare a diskless unit for first use
View all Netgear RND4410v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ReadyNAS Duo v2 and NV+ v2 Diskless Units If you purchased a ReadyNAS storage system without a pre-installed hard disk drive or drives, you must follow this procedure before you use your unit. The following procedure is illustrated with a Duo v2, but the same steps apply for an NV+ v2. To prepare a diskless unit for first use: 1. Obtain at least one hard disk drive that appears on the NETGEAR Hardware Compatibility List. See http://www.readynas.com/hard_disk_hcl. If you are using a previously formatted disk, see the precautions listed in Previously Formatted Disks on page 27. 2. With the unit turned off, insert a disk into a drive bay, as follows: a. Press the disk tray release latch. The tray handle pops out. Getting Started 8
Getting Started
8
ReadyNAS Duo v2 and NV+ v2
Diskless Units
If you purchased a ReadyNAS storage system without a pre-installed hard disk drive or
drives, you must follow this procedure before you use your unit. The following procedure is
illustrated with a Duo v2, but the same steps apply for an NV+ v2.
To prepare a diskless unit for first use:
1.
Obtain at least one hard disk drive that appears on the NETGEAR Hardware
Compatibility List.
See
.
If you are using a previously formatted disk, see the precautions listed in
Previously
Formatted Disks
on page
27.
2.
With the unit turned off, insert a disk into a drive bay, as follows:
a.
Press the disk tray release latch.
The tray handle pops out.