Netgear RP114 RP114 Reference Manual - Page 130
LNK/ACT LEDs Not On, Wrong network configuration - drivers
UPC - 606449021585
View all Netgear RP114 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Reference Guide for the Model RP114 Web Safe Router If the path is not working, you see this message: Request timed out If the path is not functioning correctly, you could have one of the following problems: • Wrong physical connections - Make sure the LAN LNK/ACT LED is on. If the LNK/ACT LED is off, follow the instructions in "LNK/ACT LEDs Not On" on page 11-2. - Check that the corresponding Link LEDs are on for your network interface card and for the hub ports (if any) that are connected to your workstation and router. • Wrong network configuration - Verify that the Ethernet card driver software and TCP/IP software are both installed and configured on your PC or workstation. - Verify that the IP address for your router and your workstation are correct and that the addresses are on the same subnet. 11-6 Troubleshooting