Netgear WBE750 Installation Guide - Page 1

Installation Guide BE18400 Tri-Band PoE 10G Insight Managed WiFi 7 Access Point Model WBE750 December 2023 Package contents Overview Access Point Model WBE750 Port cover (comes attached) Mount plate Shallow clip Deep clip CAUTION: Terms of Use This device must be professionally installed. It is the installer's responsibility to follow local country regulations including operations within legal frequency channels, output power and DFS requirements. Vendor or Reseller or Distributor is not responsible for illegal wireless operations. Please see Device's Terms and Conditions for more details. 1 3 2 4 1 Status LED 2 LAN/PoE port 3 DC power connector 4 Reset button Step 1: Connect the WBE750 to your network Before you install the WBE750 access point (AP) at its permanent location, first test the AP by connecting it to your network and powering it up. NOTE: The multiple mounting options for the AP are described in the NETGEAR Pro WiFi Mount Installation Guide, which you can download from netgear.com/support/download. CAUTION: After you are done testing the AP, power off the AP and let it cool down for 10 minutes before you mount it at its permanent location. The AP is designed to use a PoE cable for power and Internet, but you can use a separately purchased 12V (3.5A) power adapter and Ethernet cable: • Use a PoE cable: Connect one end of an Ethernet cable to the LAN/PoE port of the AP and connect the other end to a PoE++ switch port that supplies 802.3bt PoE++ power. Make sure that the switch has Internet connectivity. • Use a 12V (3.5A) power adapter: Connect the power adapter's DC plug to the AP, and insert the power adapter in a power outlet. Next, connect one end of an Ethernet cable to the LAN/PoE port of the AP, and connect the other end to a port on a switch or router with an Internet connection. The power LED on the AP lights. For more Information, see the table with LED information. The AP receives an IP address from a DHCP server (usually a router in your network). If your network does not include a DHCP server, the AP uses its default IP address: 192.168.0.100. Continue to step 2 on the back page WBE750 Sample connections WAX630 WiFi 6 AP Insight cloud Internet 10G PoE++ switch (MS510TXUP) 10G Router WiFi clients 2.5G Dual core uplinks Surge protectors 2.5G 2.5G WAX610Y WiFi 6 outdoor AP After starting up and during setup, the LED can light in these colors: Solid amber: The AP is starting or the Reset button was pressed. Slow blinking amber: The Internet connection is in the process of being set up. Fast blinking amber: The firmware is being updated or the AP is in the process of being reset to factory defaults because the Reset button was pressed. Solid green: The AP is functioning in standalone mode or is not connected to Insight. Slow blinking green: Insufficient power (below 802.3bt). Solid blue: The AP is functioning in Insight mode, and is connected to Insight. NOTE: Other LED behavior exists, including LED behavior for an Insight Instant Mesh network. For more information about the LED behavior, see the user manual, which you can download by visiting netgear.com/support/download.