Netgear WC7500-Wireless User Manual - Page 380

ProSAFE Wireless Controller c. Reconfigure the static IP address setting and the VLAN settings or reenable the DHCP client. For more information, see Change IP Address and VLAN Settings on a Controller-Managed Access Point on page 376 and Reenable the DHCP Client on a Controller-Managed Access Point on page 377. If you cannot connect to the access point, its IP address might be the factory default IP address. • The access point's IP address is reset to the factory default IP address. Do the following: a. Determine the factory default IP address for the model access point. Access Point Model Factory Default IP Address WAC740 192.168.0.160 WAC730 192.168.0.100 WAC720 192.168.0.100 WN370 192.168.0.160 WND930 192.168.0.100 WNDAP660 192.168.0.100 WNDAP620 192.168.0.100 WNDAP380R Not applicable1 WNDAP360 192.168.0.100 WNDAP350 192.168.0.237 WNAP320 192.168.0.100 WNAP210v2 192.168.0.236 1. The WNDAP380R does not provide a web management interface and a default IP address. The WNDAP380R can be managed only by a wireless controller in a network with a DHCP server. b. Configure a computer with a static IP address in the same subnet as the factory default IP address of your model access point and a subnet mask of 255.255.255.0. c. Use an Ethernet cable to connect the computer to the access point. d. Log back in to the access point using the factory default IP address of your model access point. e. Enter the user name and password. The user name is admin. The default password is password. The user name and password are case-sensitive. f. Select Configuration > Upgrade > Firmware Upgrade. Controller-Managed Access Points 380