Netgear WC7600 Installation Guide - Page 5
Set Up the Wireless Controller
View all Netgear WC7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Set Up the Wireless Controller To set up the wireless controller: 1. Configure your computer with a static IP address of 192.168.0.210 and a subnet mask of 255.255.255.0. 2. Connect one end of the supplied Ethernet cable to the Ethernet port on your computer and the other end to the Ethernet port on the front panel of the wireless controller. 3. Connect the supplied power cord from the wireless controller to an AC power outlet. 4. Verify that the following LEDs on the front panel are lit: LED Power Status Description The green Power LED is lit. If this LED is not lit, check the connections and check to see if the power outlet is controlled by a wall switch that is turned off. The Status LED is lit yellow while the wireless controller is initializing. After approximately two minutes, when the wireless controller has completed its initialization, the Status LED turns green. 5