Netgear WGR614v7 WGR614v7 Reference Manual - Page 32
Default Factory Settings, Automatic Key Generation Passphrase, Manual Entry Mode - as access point
View all Netgear WGR614v7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
54 Mbps Wireless Router WGR614v7 Reference Manual • Automatic Key Generation (Passphrase): Enter a word or group of printable characters in the Passphrase box and click the Generate button to automatically configure the WEP Key(s). If encryption strength is set to 64 bit, then each of the four key boxes will automatically be populated with key values. If encryption strength is set to 128 bit, then only the selected WEP key box will automatically be populated with key values. • Manual Entry Mode: Select which of the four keys will be used and enter the matching WEP key information for your network in the selected key box. For 64 bit WEP: Enter ten hexadecimal digits (any combination of 0-9, A-F). For 128 bit WEP: Enter twenty-six hexadecimal digits (any combination of 0-9, A-F). - WPA-PSK (Wi-Fi Protected Access Pre-Shared Key): use WPA-PSK standard encryption • Security Encryption (WPA-PSK): Enter a word or group of printable characters in the Passphrase box. The Passphrase must be 8 to 63 characters in length. Default Factory Settings When you first receive your WGR614v7, the default factory settings are shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the wireless router, use the procedures below to customize any of the settings to better meet your networking needs. FEATURE Wireless Access Point Wireless Access List (MAC Filtering) SSID broadcast SSID 11b/g RF Channel Mode Authentication Type WEP DEFAULT FACTORY SETTINGS Enabled All wireless stations allowed Enabled NETGEAR 11 g and b Open System Disabled 3-10 Configuring the Internet and Wireless Settings April 2006