Netgear WGT624v3 WGT624v3 Reference Manual - Page 47
Viewing a List of Attached Devices, Upgrading the Router Software - software for
View all Netgear WGT624v3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3 Show Statistics action buttons are described in Table 5-2 Table 5-2. Field Set Interval Stop Show Statistics action buttons Description Enter a time and click the button to set the polling frequency. Click the Stop button to freeze the polling information. Viewing a List of Attached Devices The Attached Devices menu contains a table of all IP devices that the router has discovered on the local network. From the Main Menu of the browser interface, under the Maintenance heading, select Attached Devices to view the table, shown below: Figure 5-4: Attached Devices menu For each device, the table shows the IP address, NetBIOS Host Name (if available), and Ethernet MAC address. Note that if the router is rebooted, the table data is lost until the router rediscovers the devices. To force the router to look for attached devices, click the Refresh button. Upgrading the Router Software The router software of the WGT624 v3 wireless router is stored in FLASH memory, and can be upgraded as new software is released by NETGEAR. Note: The web browser used to upload new firmware into the WGT624 v3 wireless router must support HTTP uploads. Use Microsoft Internet Explorer or Netscape Navigator 4.0 or above. Do not interrupt the upgrade process once it has started. Maintenance 5-5 202-10090-01, April 2005