Netgear WNDR3400v2 WNDR3400v2 Install Guide - Page 1
Netgear WNDR3400v2 Manual
View all Netgear WNDR3400v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Guide N600 Wireless Dual Band Router WNDR3400v2 Package Contents: 2.4 GHz GHz 5 Ethernet cable Power adapter Router stand (two pieces) N600 Wireless Router (with stand attached) GHz 5 5 GHz 2.4 GHz 2.4 GHz GHz Attach the STAND to the ROUTER: 1. Position the router so that the Power button is at the bottom and the USB port is at the top. 2. Snap each piece of the stand onto a bottom corner of the router. Step 1: Unplug the power to turn off your MODEM. Internet DSL or Cable Modem Step 2: Connect one end of the yellow Ethernet cable ( ) to your MODEM, and and the other end to the Internet port on your ROUTER. (not included) Step 3: Plug in, then turn on your MODEM. Wait approximately 2 minutes until your modem turns on. If your modem has a battery backup, first remove and reinsert the battery before connecting your modem to power. Power On/Off N600 Wireless Router Laptop or Desktop Computer Step 4: Connect the power adapter to the ROUTER, then plug it into an outlet. Wait for the 2.4 GHz LED ( 2.4GHz ) to turn on. If none of the LEDs turn on, make sure the Power On/Off button is in the ON position (pushed in). Step 5: Connect your computer to the ROUTER ( ). Use another Ethernet cable to establish a wired connection as shown in this diagram. Optionally, connect wirelessly by using the preset wireless security settings located on the bottom label. Step 6: Open a browser If the web page doesn't display close and re-open the browser to http://routerlogin.net in the address bar, or check the "Troubleshooting" section on the back of this installation guide.