Netgear WNR2000-100NAR WNR2000 Setup Manual - Page 8
Table 1., Status Light Descriptions, You can use the status lights to verify various conditions. - software
View all Netgear WNR2000-100NAR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
You can use the status lights to verify various conditions. Table 1 describes each light. Table 1. Status Light Descriptions Label LED Activity Solid Amber Solid Green 1. Power Fast blink-Green Slow blink-Green Off 2. Internet Solid Amber Solid Green Blinking Green Off 3. Wireless Solid Blue Blinking Blue Off Solid Green Blinking Green 4. LAN Solid Amber (Ports 1-4) Blinking Amber Off 5. Push 'N' Connect Solid Green Blinking Green Off Description The router is performing the power-on self-test diagnostic. The power is on and the router is ready. A software update is in progress. There is a problem with the wireless router software. Power is not being supplied to the router No IP address acquired. The wireless router has acquired an Internet address. Data is being communicated with the Internet. No Ethernet cable is connected to the modem. The wireless interface is enabled. Data is being communicated over the wireless network. The wireless interface is turned off. The local port is connected to a 100 Mbps device. Data is being transmitted at 100 Mbps. The local port is connected to a 10 Mbps device. Data is being transmitted at 10 Mbps. No link is detected on this port. Indicates a (WPS) connection to a WPS-capable device. WPA-capable device can associate with the router within 2 minutes. No WPS connection exists. 4 Getting to Know Your Wireless Router