Netgear WPNT834 WPNT834 Reference Manual - Page 46
Default Factory Settings, How to Set Up and Test Basic Wireless Connectivity, admin, password, Apply - disconnect
UPC - 606449044744
View all Netgear WPNT834 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Reference Manual for the RangeMax 240 Wireless Router WPNT834 Default Factory Settings When you first receive your WPNT834, the default factory settings are in effect, as shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the WPNT834 router, use the procedures below to customize any of the settings to better meet your networking needs. FEATURE Wireless Router Radio Wireless Access List (MAC Filtering) SSID broadcast SSID 802.11b/g RF Channel Mode Authentication Type WEP DHCP Server DHCP range DEFAULT FACTORY SETTINGS Enabled All wireless stations allowed Enabled NETGEAR 11 Auto 108 Automatic Disabled Enabled 192.168.1.2 to 192.168.1.254 How to Set Up and Test Basic Wireless Connectivity Note: If you use a wireless computer to configure WPA settings, you will be disconnected when you click Apply. Reconfigure your wireless adapter to match the new settings or access the wireless router from a wired computer to make any further changes. Follow the instructions below to set up and test basic wireless connectivity. Once you have established basic wireless connectivity, you can enable security settings appropriate to your needs. 1. Log in to the WPNT834 firewall at its default LAN address of http://www.routerlogin.net (or http://192.168.1.1) with its default user name of admin and default password of password, or using whatever LAN address and password you have set up. 4-8 Wireless Configuration v1.0, November 2005