Nextar M930 Instruction Manual - Page 7

Clock Button, Loudness Button, Scan Button - wiring

Get Nextar M930 PDF manuals and user guides View all Nextar M930 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

In radio mode, press the ST briefly to select stereo or mono sound mode. 22. CLOCK BUTTON Press the CLK button briefly to display time for 5 seconds on the display, and then returns to its previous display unless the button is pressed again. Then press the CLK button and hold for more than 1 seconds until the real time flashes on the display. Then you can adjust HOUR or MINUTE by pressing the V.UP(+) and V.DN(-) button, respectively. 23. LOUDNESS BUTTON When press shortly, the LOUD mode is turned on, its to enhance the bass sound effect when the volume level is low. Press again to cancel the loudness effect. 24. SCAN BUTTON Press the SCN button to scan the radio frequency. If a valid signal has detected, the current frequency will be hold and blinked for 5 seconds, then press SCN again to stop scan and remain the current frequency; otherwise, the radio will go on to scan the other radio frequency fiver seconds later. Note: 1.Make sure use a speaker with 4 ohm load impedance. 2.Do not make the auto antenna wire and ground touch each other . E 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
In radio mode, press the ST briefly to select stereo or mono sound mode.
22. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and
then returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 seconds until the real time
flashes on the display.
Then you can adjust HOUR or MINUTE by pressing the V.UP(+) and V.DN(-)
button, respectively.
23. LOUDNESS BUTTON
When press shortly, the LOUD mode is turned on, its to enhance the bass sound
effect when the volume level is low. Press again to cancel the loudness effect.
24. SCAN BUTTON
Press the SCN button to scan the radio frequency. If a valid signal has
detected, the current frequency will be hold and blinked for 5 seconds,
then press SCN again to stop scan and remain the current frequency;
otherwise, the radio will go on to scan the other radio frequency fiver
seconds later.
Note:
1.Make sure use a speaker with 4 ohm load impedance.
2.Do not make the auto antenna wire and ground touch each other
.
E 6