Nextar MP307 MP307 Instruction Manual - Page 5

Identification of Controls Remote Control Operation The instruction in this manual describe the functions on the remote control. See the page for the details. Remote Control Operation Button POWER EJECT MUTE SETUP ENTER CLEAR 0-9,+10 REPEAT VOL+,VOLSYSTEM PBC OFF DVD DIGEST TITLE SURROUND VOCAL ASSIS SLOW AV-SEL Function Power on/off DVD To eject a disc or eject a disc Playing without Function Setup Select target or enter menu Clear the wrong number you entered Select desired channel with #button directly To play repeedly To control the volume Change video system PAL and NTSC in turn Play back control on/off Locating a specific title chapter or track Audio mode select To select the Audio functions Change play speed to slow To Select External/Internal Video To change the playback speed To locate preceding/succeeding chapter or track Joy stick To stop back To pause playback (step mode) POWER EJECT 1 2 3 4 5 6 7 8 CLEAR 9 0 +10 SETUP ENTER VOL SURROUND VOCAL ASSIST PBC OFF MUTE SYSTEM AV SEL TITLE DVD DIGEST REPEAT SLOW Identification of Controls Preparing the remote control Insert the cell into the remote control so you can use it to operate the DVD video player. Make sure to match the + and on the lithium button cell (3V, CR2025) to the marks inside the cell compartment. Open the cover, pull the as illustrated Insert Cell (3V) Close the Cover Operating with the remote control This section shows you how to use the remote control. Point the remote control at the remote sensor and press the buttons. Not used when using the remote sensor on the remote control eye jack. The remote range: about 6cm from the front of the remote sensor. (ls) off axis: about 30 in each direction of the front of the remote sensor. 30 30 Do not expose the remote sensor of the DVD player and the remote control to a strong light source such as direct sunlight or other illumination. If you may not be able to operate the DVD player via the remote control. NOTE ON BATTERY To operate the remote control correctly, follow the instructions. Below. Do not insert cell into the remote control in the wrong direction. Do not charge, heat, open, or short-crcuit the cell. Do not throw cell into a fire. If the remote control does not function correctly of if the operating range becomes reduced, replace the cell with new one. NOTES ON REMOTE CONTROL Direct the remote control at the remote sensor of the DVD player. Do not drop or give the remote control a shock. Do not leave the remote control near an extremely hot or humid place. Do not spill water or put anything wet on the remove control. Do not disassemble the remote control. 6 7