Nikon 8405 User Guide - Page 5

crosshairs to the bullet or simply measure how

Get Nikon 8405 - Omega Riflescope With Bullet Drop PDF manuals and user guides
UPC - 018208084050
View all Nikon 8405 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

have a friend carefully turn the turrets while you look through the scope and provide directions. Fire one shot to confirm that your scope is now zeroed on the close range dot. Make minor corrections if required. The object is to get the point of aim identical to the point of impact. Now move your large target paper to one hundred yards. Enlarge the aiming dot to two inches with your felt pen. Place small pieces of masking tape over the short-range bullet holes or simply mark them with the felt pen. Now fire a shot and again the bullet should hit somewhere on the large target paper. You can repeat the previous technique of moving the crosshairs to the bullet or simply measure how much correction will be required to bring the bullet to the aiming dot. If you are six inches low and four inches right, move the elevation turret 24 clicks up and the windage turret 16 clicks left. Once again - the objective is to get the point of aim identical to the point of impact.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
have a friend carefully turn the turrets while
you look through the scope and provide
directions. Fire one shot to confirm that your
scope is now zeroed on the close range dot.
Make minor corrections if required. The object
is to get the point of aim identical to the point
of impact.
Now move your large target paper to one
hundred yards. Enlarge the aiming dot to two
inches with your felt pen. Place small pieces of
masking tape over the short-range bullet holes
or simply mark them with the felt pen. Now
fire a shot and again the bullet should hit
somewhere on the large target paper. You can
repeat the previous technique of moving the
crosshairs to the bullet or simply measure how
much correction will be required to bring the
bullet to the aiming dot. If you are six inches
low and four inches right, move the elevation
turret 24 clicks up and the windage turret 16
clicks left. Once again - the objective is to get
the point of aim identical to the point of
impact.