Nikon Nikon Df Product Manual - Page 345

Software Wireless remote controllers Accessory terminal accessories • Capture NX 2: A complete photo editing package with such advanced editing features as selection control points and an auto retouch brush. • Camera Control Pro 2: Control the camera remotely from a computer to take photos and save them directly to the computer hard disk. When Camera Control Pro 2 is used to capture photographs directly to the computer, a PC connection indicator c will appear in the control panel. Note: Use the latest versions of Nikon software; see the websites listed on page xvii for the latest information on supported operating systems. At default settings, Nikon Message Center 2 will periodically check for updates to Nikon software and firmware while you are logged in to an account on the computer and the computer is connected to the Internet. A message is automatically displayed when an update is found. • Wireless Remote Controller WR-R10/WR-T10: When a WR-R10 wireless remote controller is attached to the camera accessory terminal, the camera can be controlled wirelessly using a WR-T10 wireless remote controller. • Wireless Remote Controller WR-1: WR-1 units are used in groups of two or more, with one functioning as a transmitter and the remaining units acting receivers. The receivers are attached to the accessory terminals of one or more cameras, allowing the transmitter to be used to release the camera shutters. The Df is equipped with an accessory terminal for MC-DC2 remote cords (0 44) and GP-1 and GP-1A GPS units (0 170), which connect with the 4 mark on the connector aligned with the 2 next to the accessory terminal (close the camera connector cover when the terminal is not in use). n 325