Nokia LD-3W User Guide - Page 6

Basic use - connected

Page 6 highlights

ENGLISH Warning! Use only batteries and chargers approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Install the battery See Figure 2 at the start of this guide. 1. To open the back cover of the GPS module, press the release button (1), and slide the cover away from the device (2). 2. Insert the battery (3). 3. Close the back cover (4), and slide it in the direction of the arrow (5) until it locks into place. Charge the battery 1. Plug the charger into its connector on the GPS module. 2. Connect the charger to a power outlet. During charging, the green or red indicator light blinks, depending on whether the GPS module is on (green) or off (red). When the battery is fully charged and the power is on, the green light is displayed continuously. When the battery is fully charged and the power is off, the red light stops to blink. 3. Disconnect the charger from the power outlet and the GPS module. When the battery is running out of power, the red indicator light on the GPS module starts to blink every 15 seconds. Recharge the battery. Basic use The GPS module should only be used outdoors to allow reception of GPS signals. GPS should not be used for precise location measurement, and you should never rely solely on location data from the

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10

ENGLISH
Warning!
Use only batteries and
chargers approved by Nokia for
use with this particular device.
The use of any other types may
invalidate any approval or
warranty, and may be
dangerous.
When you disconnect the power cord of
any enhancement, grasp and pull the plug,
not the cord.
Install the battery
See Figure 2 at the start of this guide.
1.
To open the back cover of the GPS
module, press the release button (1),
and slide the cover away from the
device (2).
2.
Insert the battery (3).
3.
Close the back cover (4), and slide it in
the direction of the arrow (5) until it
locks into place.
Charge the battery
1.
Plug the charger into its connector on
the GPS module.
2.
Connect the charger to a power outlet.
During charging, the green or red
indicator light blinks, depending on
whether the GPS module is on (green)
or off (red).
When the battery is fully charged and
the power is on, the green light is
displayed continuously. When the
battery is fully charged and the power
is off, the red light stops to blink.
3.
Disconnect the charger from the
power outlet and the GPS module.
When the battery is running out of power,
the red indicator light on the GPS module
starts to blink every 15 seconds. Recharge
the battery.
Basic use
The GPS module should only be used
outdoors to allow reception of GPS
signals.
GPS should not be used for precise
location measurement, and you should
never rely solely on location data from the