NordicTrack 9600 Elliptical Uk Manual - Page 8

HOW TO SET UP THE ELLIPTICAL TRAINER HOW TO MOVE AND LEVEL THE ELLIPTICAL TRAINER Make sure that the power cord is unplugged. (Note: If a CATV cable is connected to the elliptical trainer, it may be necessary to disconnect the cable if the elliptical trainer will be moved far.) Next, see the left inset drawing and locate the two levelling feet under the rear of the frame. Turn the levelling feet so that they are not touching the floor. Lift Here Due to the size and weight of the elliptical trainer, moving it requires two persons. Have two persons lift the indicated end of the elliptical trainer until the elliptical trainer will roll on the front wheels. Carefully move the elliptical trainer to the desired location and then lower it back to the level position. CAUTION: To decrease the risk of injury, bend your legs and keep your back straight. Make sure to use your legs rather than your back to lift the elliptical trainer. Do not attempt to move the elliptical trainer over an uneven surface. Next, turn the two levelling feet under the rear of the frame until they are just touching the floor. If the elliptical trainer rocks slightly during use, turn the levelling feet under the front of the frame (see the right inset drawing) until the rocking motion is eliminated. HOW TO CONNECT THE POWER CORD If the elliptical trainer has a Basic console, it can be used with or without a power cord. To purchase a power cord, see HOW TO CONTACT CUSTOMER CARE on page 2 of this manual. If the elliptical trainer has a Workout TV console, a power cord must be used for the TV to be operated. A power cord is included with the Workout TV console. To use a power cord, first plug one end of the power cord into the jack on the front of the elliptical trainer. Plug the other end of the power cord into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. Levelling Feet Power Cord Jack Wheels 7