NordicTrack A2155 Treadmill English Manual - Page 9

8. Have a second person hold the Bridge (95) near the Right Upright (78). Remove the wire tie from 8 the Upright Wire (38). Connect the Upright Wire (38) to the Bridge Wire (52). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Wire Tie 95 52 38 78 52 38 9. Insert the indicated connectors and tie into the Right Upright (78). Next, insert the fronts of the brackets on the Bridge (95) into the Uprights (74, 78), and then fully insert the brackets. Make sure that the plastic edges of the Bridge are inside the Uprights. Attach the Bridge (95) with six 1/4" x 1/2" Bolts (7) and six 1/4" Star Washers (10); start the two Bolts indicated by the arrows first before starting the other four Bolts. Tighten all six Bolts. See steps 4 and 6. Tighten the four 3/8" x 4 1/2" Bolts (6). 9 7 10 74 95 Connectors 7 Front Edge 7 10 7 Tie 78 10. With the help of a second person, hold the console assembly near the Bridge (95). Connect the Bridge Wire (52) to the console assembly wire. Make sure to connect the connectors properly (see the inset drawing in step 8). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. 10 Console Assembly 101 95 52 Connect the Console Ground Wire (101) to the 9 console assembly ground wire. Insert the wires into the console assembly. 5 Attach the console assembly with three 3/8" x 1 1/4" Bolts (5) and three 3/8" Star Washers (9). Be careful not to pinch the wires. 9