NordicTrack Audiorider U300 Bike Canadian English Manual - Page 16

MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight. TIGHTENING THE PEDALS For best performance, regularly tighten both pedals. CONSOLE TROUBLESHOOTING If the console display becomes dim, the batteries should be replaced. See assembly step 5 on page 7 for replacement instructions. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 12. HOW TO LEVEL THE EXERCISE CYCLE If the exercise cycle does not sit flat on your floor, turn one or both of the leveling feet until the exercise cycle is level. Leveling Feet HOW TO ADJUST THE REED SWITCH If the console does not display correct 4 feedback, the reed switch should be 8 adjusted. First, use a small flat screwdriver to carefully pry off the left Side Shield 14 Cover (14). Next, rotate the left Pedal Guard (8) and pull it away from the Left Side Shield (4). Next, locate the Reed Switch (49). Turn the Left Crank Arm (15) 15 until the Magnet (23) is aligned with the Reed 49 23 Switch. Loosen, but do 54 not remove, the indicated M4 x 16mm Screw (54). Slide the Reed Switch slightly closer to or away from the Magnet. Then, retighten the Screw. Turn the Left Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left Pedal Guard (8) and the left Side Shield Cover (14). 16