NordicTrack Cx 1000 Elliptical English Manual - Page 7

4. Identify the Left Crank Arm (36), which is marked 4 with a sticker. Hold the Left Crank Arm against the left Crank Hub (38), and align the holes in the Left Crank Arm with the unused holes in the Crank Hub. Next, insert four Hub Screws (87) into the Left 123 38 Crank Arm, and finger tighten the Hub Screws into the Crank Hub. Tighten one of the Hub Screws, and then tighten the Hub Screw farthest from the first Hub Screw. Then, tighten the remaining two Hub Screws. 75 87 116 Attach a Hub Cover (75) to the Left Crank Arm (36) with four M8 x 15mm Button Screws (116). Repeat this step on the other side of the elliptical exerciser. Make sure that the Crank Arms (36, 123) are oriented as shown. 87 36 116 Cutout 5. While another person holds the Upright (3), connect 5 the Upper Wire Harness (48) to the Lower Wire Harness (49). Gently pull the upper end of the Upper Wire Harness to remove any slack, and insert the Upright into the Base (1). Attach the Upright with an M8 x 69mm Button Bolt (80), an M8 Split Washer (90), and an M8 Jam Nut (79). Do not tighten the Button Bolt yet; make sure that the Jam Nut is in the hexagonal hole in the Base. Next, finger tighten two M8 x 23mm Button Screws (84) with M8 Split Washers (90) into the Base (1). Do not tighten the Button Screws yet. Attach the Water Bottle Holder (22) to the Base (1) with two M4 x 14mm Screws (104). 80 90 90 84 3 48 49 79 90 84 104 1 22 6. Insert the end of the Upper Wire Harness (48) through the rectangular hole in the Console Bracket (4). Attach the Console Bracket to the Upright (3) with four M6 x 20mm Button Screws (77). Orient one of the Upright Covers (17) as shown, and hold it against the Upright (3). Attach the Upright Cover with two M4 x 16mm Round Head Screws (101). Attach the other Upright Cover in the same way. 6 48 77 3 77 17 101 4 101 17 7