NordicTrack Cx 920 Elliptical English Manual - Page 6
Slide an M8 Split Washer 58 and an M8 Washer 33
View all NordicTrack Cx 920 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
1. Identify the Rear Stabilizer (94), which has two Leveling 1 Feet (59) threaded into it. Turn the Rear Stabilizer so the Leveling Feet are closer to the rear of the Frame (1) as shown. Attach the Rear Stabilizer to the Frame with the four M10 x 56mm Button Screws (60) and four M10 Split Washers (22). 60 22 60 22 1 94 2. Attach the Front Stabilizer (90) to the Frame (1) with 2 the four M10 x 43mm Button Screws (97) and four M10 Split Washers (22). Make sure that the Front Stabilizer is turned so the Wheels (45) are not touching the floor. 59 97 22 22 1 45 90 3. Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Button Screw (30). Tighten the Button Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle. Align the indicated tubes on the Incline Frame (5) with the tubes on the Frame (1). Make sure that the Incline Frame is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Frame and the Frame. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it. Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other M8 x 19mm Button Screw (30). Tighten the Button Screw into the open end of the Incline Axle (29). 3 Grease 29 33 58 V-shaped Groove 5 33 58 30 Tubes 30 1 Tubes 6