NordicTrack Cxt 970 User Manual - Page 8

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (refer to page 19), follow the steps below to install the receiver and the Y-connector included with the chest pulse sensor. 1. Remove the four indicated screws from the back of the Console (87). Lift the top of the Console. Be careful not to disconnect any wires. 1 Screws 87 2. Peel the paper off the adhesive pad on the back of the receiver (A). Orient the receiver exactly as shown, and 2 press it onto the Console (87) in the indicated location. Connect the wire on the receiver (A) to the Y-connector (B) as shown. Unplug the indicated console wire (C) from the indicated jack (D), and plug the console wire into the Y-connector. Then, plug the Y-connector into the jack (D). Refer to step 1 above. Reattach the top of the Console (87) with the four screws. Make sure that no wires are pinched. Note: Any other wires that are included with the chest pulse sensor may be discarded. A 87 D C B Cylinder 8