NordicTrack E 10.7 Elliptical English Manual - Page 32

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO GREASE THE TRACKS For optimal performance, apply a small amount of PTFE grease to the tracks on the ramp every three months. See assembly step 13 on page 14 for instructions. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. First, press the power switch to the off position and unplug the power cord. See the drawing below. Remove the M8 x 14mm Shoulder Screw (89), the Roller Arm Cover (14), and the M8 Washer (not shown) from the Left Roller Arm (40). CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 23. 28 89 14 29 40 38 If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 15. If it is difficult for you to touch the correct buttons on the screen, the screen may not be properly calibrated. To calibrate the screen, see step 5 on page 29. See assembly step 10 on page 12. Remove the Upper Body Covers A and B (31, 32) from the Left Upper Body Arm (27). See assembly step 9 on page 12. Remove the Left Upper Body Arm (27) from the Left Upper Body Leg (28). See the drawing above. Remove the Left Roller Arm (40), the Left Pedal Arm (38), and the Left Upper Body Leg (28) from the elliptical. Then, using a flat screwdriver, gently pry off the left Disc (29). 32