NordicTrack E 7.5 I Elliptical English Manual - Page 10

Make sure that the Locknuts are in

Get NordicTrack E 7.5 I Elliptical PDF manuals and user guides View all NordicTrack E 7.5 I Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

7. Using a plastic bag to keep your fingers clean, apply some of the included grease to the Pivot Axle (35) and to two 16mm Wave Washers (54). Insert the Pivot Axle (35) through the Upright (4) and center it. Tip: It may be helpful to use a rubber mallet. Next, identify the Right Upper Body Leg (60) and orient it as shown. Slide a 16mm Wave Washer (54) and the Right Upper Body Leg (60) onto the right side of the Pivot Axle (35). Repeat these actions for the Left Upper Body Leg (46). Then, tighten an M8 x 13mm Screw (82) with an M8 Washer (97) into each end of the Pivot Axle (35) at the same time. 7 46 4 35 Grease 54 60 97 82 8. Identify the Right Upper Body Arm (61) and orient it as shown. Slide the Right Upper Body Arm (61) onto the Right Upper Body Leg (60). Attach the Right Upper Body Arm (61) with two M8 x 38mm Bolts (96) and two M8 Locknuts (102). Make sure that the Locknuts are in the hexagonal holes (C). Repeat this step for the Left Upper Body Arm (47). 8 47 102 60 C 61 96 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
10
7
7.
Using a plastic bag to keep your fingers clean,
apply some of the included grease to the Pivot
Axle (35) and to two 16mm Wave Washers (54).
Insert the Pivot Axle (35) through the Upright (4)
and center it.
Tip: It may be helpful to use a
rubber mallet.
Next, identify the Right Upper Body Leg (60) and
orient it as shown.
Slide a 16mm Wave Washer (54) and the Right
Upper Body Leg (60) onto the right side of the
Pivot Axle (35).
Repeat these actions for the Left Upper Body
Leg (46).
Then, tighten an M8 x 13mm Screw (82) with an
M8 Washer (97) into each end of the Pivot Axle
(35)
at the same time.
60
54
46
82
97
35
4
Grease
8
8.
Identify the Right Upper Body Arm (61) and
orient it as shown.
Slide the Right Upper Body Arm (61) onto the
Right Upper Body Leg (60).
Attach the Right Upper Body Arm (61) with two
M8 x 38mm Bolts (96) and two M8 Locknuts
(102).
Make sure that the Locknuts are in the
hexagonal holes (C).
Repeat this step for the Left Upper Body
Arm (47).
60
61
47
96
102
C