NordicTrack E7.0 Elliptical Uk Manual - Page 22
Maintenance And Troubleshooting
View all NordicTrack E7.0 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. Next, look into the access opening and locate the Reed Switch (69). Rotate the Large Pulley (74) until a Pulley Magnet (75) is aligned with the Reed Switch. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power adapter is fully plugged in. If lines appear in the console display, see HOW TO USE THE INFORMATION MODE on page 20 and adjust the contrast level of the display. If the handgrip pulse sensor does not function properly, see step 5 on page 18. 106 75 74 69 HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first unplug the power adapter. Using a flat screwdriver, release the tabs on the Access Cover (20) and pry the Access Cover upward off the elliptical. Next, loosen, but do not remove, the indicated M4 x 16mm Screw (106). Slide the Reed Switch (69) slightly toward or away from the Pulley Magnet (75). Then, retighten the M4 x 16mm Screw. Plug in the power adapter and rotate the large pulley 20 for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the access cover. 22