NordicTrack Elite 13.1 Elliptical English Manual - Page 32
HOW TO ADJUST THE DRIVE BELT, unplug the power cord.
 |
View all NordicTrack Elite 13.1 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power cord. Then, look between the Left and Right Shields (73, 74) and locate the M8 Locknut (102). Tighten the Locknut until the Drive Belt (113) is tight. Next, use a standard screwdriver and pry off the Shield Cover (56) and slide it upward. 113 56 102 73 74 When you have properly adjusted the drive belt, 75 reattach the rear shield and press the shield cover onto the rear shield. Then, remove the four M4 x 16mm Screws (not shown) from the upper and lower ends of the Rear Shield (75), and remove the Rear Shield. 32
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27 -
28 -
29 -
30 -
31 -
32 -
33 -
34 -
35 -
36 -
37 -
38
-
39
-
40
 |
 |
32
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. To adjust the drive belt,
first
unplug the power cord.
Next, use a standard screwdriver and pry off the Shield
Cover (56) and slide it upward.
Then, remove the four M4 x 16mm Screws (not shown)
from the upper and lower ends of the Rear Shield (75),
and remove the Rear Shield.
Then, look between the Left and Right Shields (73, 74)
and locate the M8 Locknut (102). Tighten the Locknut
until the Drive Belt (113) is tight.
When you have properly adjusted the drive belt,
reattach the rear shield and press the shield cover onto
the rear shield.
56
73
113
75
74
102