NordicTrack Gx 5.1 English Manual - Page 9
and Loop Fasteners 68. Press a Fastener onto
View all NordicTrack Gx 5.1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
11. The Transmitter (69) requires two AAA batteries (not included); alkaline batteries are 11 recommended. Remove the battery cover from the front of the Transmitter (69), and insert batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagrams inside the battery compartment. Then, reattach the battery cover. Remove the adhesive backing from the Hook and Loop Fasteners (68). Press a Fastener onto the Frame (1) in the indicated location. Orient the Transmitter (69) as shown. Press the other Fastener (68) onto the back of the Transmitter. Attach the Transmitter (69) to the Frame (1) using the Hook and Loop Fasteners (68). 12. Plug the Reed Switch (67) into the Transmitter (69). 12 Insert the other end of the Reed Switch (67) into the Clamp (62). Rotate the Flywheel (33) until the Magnet (70) is aligned with the end of the Reed Switch (67). Move the Reed Switch (67) so that the gap between the Reed Switch and the Magnet (70) is about 1/8 in. (3 mm). 69 Battery 1 68 Cover 70 62 33 69 67 13. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor. 9