NordicTrack T 6.7i Treadmill English Manual - Page 16

14. Remove the 5/16" Nut (34) and the 5/16" x 2 1/4" Bolt (25) from the bracket on the Latch Crossbar (41). Align the upper end of the Storage Latch (26) with the bracket on the Latch Crossbar (41), and insert the 5/16" x 2 1/4" Bolt (25) through the bracket and the Storage Latch. This will push a spacer (M) out of the Storage Latch; discard the spacer. Next, tighten the 5/16" Nut (34) onto the 5/16" x 2 1/4" Bolt (25). Do not overtighten the Nut; the Storage Latch (26) must be able to pivot. Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 26). 14 34 M 41 25 56 26 15. Firmly tighten the four 3/8" x 2 3/8" Screws (7), the two 3/8" x 1 3/4" Screws (62), and the 15 two 3/8" x 1 1/4" Screws (63). Next, set the Left Inner Base Cover (50) onto the lower end of the Left Upright (89). Slide the Left Base Cover (82) downward and press it onto the Left Inner Base Cover. Then, set the Right Inner Base Cover (51) onto the lower end of the Right Upright (90). Slide the 83 Right Base Cover (83) downward and press it onto the Right Inner Base Cover. 89 82 50 63 7 62 51 62 63 90 7 16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 28 and 29). Note: Extra hardware may be included. 16