NordicTrack T16.0 Instruction Manual - Page 8
shown; save the Screws., each side of the Base 94 only one side is
View all NordicTrack T16.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Pull the Upright Wire (81) and the base ground wire (A) through the indicated hole in the Base (94). If there is a screw (B) pre-installed in the side of the Base (94), remove and discard the screw. Then, attach the base ground wire (A) to the Base with a #8 x 1/2" Silver Screw (10). Make sure that the Grommet (77) is pressed into the square hole in the Base (94). See the inset drawing. Cut the plastic tie near the Upright Wire (81). 3 Square Hole Tie Hole 77 81 10 A B 94 Tie Cut 81 4. Identify the Left Upright (89). Have a second person hold the Left Upright near the Base (94). See the inset drawing. Tie the wire tie (C) in the Left Upright (89) securely around the end of the Upright Wire (81). Then, pull the other end of the wire tie until the Upright Wire is routed through the Left Upright. Then, remove the two 3/8" x 2 3/4" Screws (7) and the two 3/8" x 1 1/4" Screws (8) from each side of the Base (94) (only one side is shown); save the Screws. 4 89 81 89 C 7 C 81 81 8 94 8