Oki B6250dn B6250 Network Guide - Page 18
Target Computers, Interface, Set Up Procedure, Daemon Protocol. Lpd Tcp/ip Unix
View all Oki B6250dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
The printer LPD supports Spool Mode where print jobs from clients are spooled once before output and Non-spool Mode where print jobs are sequentially output without spooling. LPD (TCP/IP) NOTE When the LPD port is used, the printer can limit print instructions by IP addresses. TARGET COMPUTERS The target computers are as follows: • Workstation or personal computer with RFC 1179 Line Printer Daemon Protocol. LPD (TCP/IP) UNIX INTERFACE The printer LPD is available on the following interfaces: • Ethernet 100BaseTX • Ethernet 10Base-T The applicable frame types conform to Ethernet II. SET UP PROCEDURE The setting procedure is as follows: 1. Setting up the printer Set the IP address on the printer Operator Panel. Use the printer Operator Panel or the EWS to set the LPD port to [Enable] (default: [Enable]). NOTE > Before activating the LPD port, set the IP address of the printer. For details on how to set the IP address and the port, refer Printer Configuration. B6250 Network Guide> 16