Oki B6300nSmartFormsSolutions B6200/6300 Technical Reference/User's Guide - Page 68
Sets the parity. Select from [Not Available] [Odd] [Even]. The default is [Not Available].
View all Oki B6300nSmartFormsSolutions manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
n Auto Eject Time*3 (refer to P. 83) Sets the time interval for the printer to automatically print the remaining data when no further data is received for a continuous period. The time can be set between 5 to 1275 seconds in increments of 5 seconds. The default is [30 Secs]. When no data is received for the period specified here after the last data was received, the printer determines it as job end. n Baud rate Sets the baud rate. Select from [9600bps] [19200bps] [38400bps] [57600bps] [115200bps] [4800bps]. The default is [9600bps]. n Stop Bit Select the stop bit from [1 bit] or [2 bits]. The default is [1 bit]. n Parity Sets the parity. Select from [Not Available] [Odd] [Even]. The default is [Not Available]. n XON - XOFF Control Sets whether to enable or disable the XON/XOFF control at the flow control. The default is [On]. n DTR Control Sets the DTR control from [Fix-High] [Fix-Low] [Active-High] [Active-Low]. The default is [Fix-High]. LPD Select this to use LPD. n Port Status Specifies whether to enable or disable the LPD port when the printer turns on. The default is [Enable], which means the LPD port is available. Note • To enable the LPD port, the IP address must be set. Important • If the memory is running out when the port is enabled, the port may be disabled automatically. In this case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate Memory]. n Print Mode*1 (refer to P. 83) Sets the print data process method (printer language to be used). [Auto] (default) Select this to make the printer automatically detect the printer language being used in the data received from a computer and perform printing based on the detected data. [PCL] [PS] [ESC/P] [HP-GL/2] [TIFF] Select this to process the data received from a computer as the specified data type. n PJL *2 (refer to P. 83) This printer supports PJL commands that are independent from any printer languages. The PJL commands are used to control print jobs and are required for printing using a printer driver. In this menu, specify whether to enable or disable the PJL commands sent from a computer. PJL commands allow you to specify the printer language to be used for the next data even while the printer is using a different printer language at the time. Normally, it should be set to [Enable]. The default is [Enable]. 64 4 Settings on the Control Panel