Oki C6000n C6000n Safety, Warranty, and Regulatory Information - Page 8

Hazardous Decomposition or Byproducts: Combustion products include harmful gases such as carbon monoxide and nitrogen oxides. Incompatibility: Not available. Preventive Measures Personal Protective Equipment Respiratory Protection: Not normally required. For large spills, use dust respirator during cleanup. Protective Gloves and/or Eye Protection: Not normally required. For large spills, use rubber gloves and safety goggles during cleanup. Engineering Controls Ventilation: Outside of normal ventilation, not normally required. Other Protective Equipment and/or Hygienic Practices: None. Spill Cleanup Small Spills 1. Remove sources of ignition. 2. Carefully clean up the spill with a wet cloth, avoiding inhalation of fine dust. Large Spills 1. Remove sources of ignition and keep unnecessary and unprotected personnel away from area. 2. Wear protective gear: respirator, rubber gloves, safety goggles. 3. Vacuum the spill, then wipe up remainder with a wet cloth. Waste Disposal • Prevent release of material into natural waters and sewers. • Follow appropriate federal, state and local regulations. • Small amounts can be incinerated. Careful! Combustion can create harmful gases such as carbon monoxide and nitrogen oxides. • Large amounts must be passed to a licensed waste contractor. Precautions Precautions for Handling or Storage: Protect from the sun. Store in a cool room, under 104°F (40°C). Keep out of reach of children. Other Precautions: None. Shipping Information Special Shipping Information: Non hazardous. Handle container carefully to avoid shock. Do not drop. Keep dry. User's Responsibility This bulletin cannot cover all possible situations which the user may experience when using this product. Each aspect of your operation must be examined in regard to if, or where, additional precautions may be necessary. All health and safety information contained in this bulletin must be provided to your employees or customers. It is your responsibility to use this information to develop appropriate work practice guidelines and employee instructional programs for your operation. Preparation Date of MSDS Date: February 1, 2007. Prepared by: Oki Data Americas, Inc Engineering Services Department. 2000 Bishops Gate Blvd. Mt. Laurel, NJ 08054-4620 Tel: (856) 235-2600 Fax: (856) 222-5320 http://www.okiprintingsolutions.com my.okidata.com English Material Safety Data Sheet #58381901 Cyan Toner: P/N 43324468 For more information, contact Oki Data at: 2000 Bishops Gate Boulevard, Mount Laurel, NJ 08054-4620. Emergency Information: call 1-800-654-3282; US and Canada only. Emergency First Aid Procedures Toner swallowed (ingested) Immediately seek medical attention. Never give anything by mouth to an unconscious person. If possible, rinse out mouth and give one or two glasses of water or milk to drink. Toner inhaled. Remove person to fresh air. Seek medical attention. Toner gets in the eyes. Flush eyes with large quantities of cool water for 15 minutes, keeping the eyelids open with fingers. If necessary, seek medical attention. Toner gets on the skin. Wash toner off the skin with plenty of cool water and soap. If necessary, seek medical attention. Note: Small amounts of toner on skin or clothing can easily be removed with soap and cold water. Hot water makes toner harder to remove. Hazardous Ingredients Silica dioxide (about 2% by weight) CAS#: Trade Secret. OSHA PEL: Not established. ACGIH TLV: Not established. LD50: Not Available. LC50: Not Available. Physical Data Physical State: Solid. Melting/Freezing Point: Not available. Boiling Point: Not available. PH: Not available. Vapor Pressure: Not available. Vapor Density (Air=1): Not available. Evaporation Rate (Butyl Acetate=1): Not available. Specific Gravity (H2O=1): 1.1 to 1.2 at 20°C (68°F). Solubility in Water: Not available. Solubility in Solvents: Some components are soluble in toluene, chloroform and tetrahydrofuran. Coefficient of water/oil Distribution: Not available. 8 - English