Oki MICROLINE 320 TURBO Supplement - Page 25

Group Item Settings Set-Up(cont.) Parallel I/F Serial I/F* Print DEL Code SI Select Pitch (10 cpi)* SI Select Pitch (12 cpi)* Time Out Print Auto Select Graphics Speed Centering Position ESC SI Pitch* Power Save Time Time Out FF I-Prime Auto Feed XT** Bi-Direction Parity Serial Data 7/8 Bits Protocol Diagnostic Test Busy Line Baud Rate DSR Signal DTR Signal Busy Time No, Yes 17.1 cpi, 15 cpi 20 cpi, 12 cpi Valid, Invalid No, Yes Low, High DEFAULT, MODE 1, MODE 2 17.1 cpi, 20 cpi 5 min, 10 min, 15 min, 30 min, 60 min Invalid, 200 ms, 500 ms, 1 sec Buffer Print, Invalid, Buffer Clear Invalid, Valid Enable, Disable None, Odd, Even 8 Bits, 7 Bits X-ON/X-OFF, ReadylBusy No, Yes SSD-, SSD+, DTR, RTS 19200 BPS, 9600 BPS, 4800 BPS, 2400 BPS, 1200 BPS, 600 BPS, 300 BPS Valid, Invalid Ready on Power Up, Ready on Select 200 ms, 1 sec * Appears only when the IBM emulation is selected. ** Appears only when the Epson emulation is selected. + The serial interface supplied in the printer is set at the factory for DEC status/response. To change the settings for use in non-DEC environments, contact the Okidata Customer Service and Support Center at 1-800-OKIDATA (1-800-654-3282). Menu Mode 21