Oki ML420n Network User's Guide for OkiLAN 6020e - Page 88
Introduction, Overview, Software Requirements, Install OkiNet for TCP/IP-see I.
View all Oki ML420n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Section 4 - Chapter 1 - Introduction Network Preparation • You should be familiar with network administration as well as the physical setup and operation of your network. • Advise users of possible disruption during installation. • Make sure the serial number and Ethernet address of your OkiLAN 6020e are available. • Assign an IP address and a hostname (alias) to the OkiLAN 6020e. Use the network name service or the "/etc/hosts" file to add the OkiLAN 6020e to the network. Before You Start Before running OkiNet for TCP/IP, you must do the following: • Install the OkiLAN 6020e hardware and connect the cabling. Instructions for hardware installation are found in Section I of this manual. • Write down the serial number and Ethernet address of your OkiLAN 6020e. (These numbers are located on the OkiLAN 6020e unit.) • Install OkiNet for TCP/IP-see Section I. Overview of TCP/IP Configuration • Assign an IP address for the OkiLAN 6020e • Configure the OkiLAN 6020e network information • Configure hosts for printing to the OkiLAN 6020e • Test print (optional) IV - 6 OKI OkiLAN 6020e User's Guide