Oki ML490 ML490/491 User's Guide (American English) - Page 36

Busy Line, Default = SSD- Appears only when the optional Serial Interface is installed. If Ready/Busy protocol (factory default) is selected, you can choose which line your system monitors for a busy signal: • SSD -9V, select SSD• SSD +9V, select SSD+ • DTR -9V, select DTR • RTS -9V, select RTS Busy Time, Default = 200 ms Appears only when the optional Serial Interface is installed. Sets the length of the busy signal when the Ready/Busy protocol (factory default) is engaged, Centering Position, Default = DEFAULT Used to limit printhead travel when printing narrow columns. • Select Mode 1 for the narrow carriage printer. • Select Mode 1 or Mode 2 for the wide carriage printer. Character Set, Default = IBM Set I Use this to switch character sets to IBM Set II Code Page, Default = USA Choose the Code Page character set you wish to use: USA, Canada French, Multilingual, Portugal, Norway, BRASCII, Abicomp, Multilingual 858, or ISO 8859-15. CSF Bin Select, Default = Bin 1 Appears only when the optional Dual-Bin Cut Sheet Feeder is installed. Use this to switch to Bin 2 as the default. CSF Type, Default = Wide To avoid paper jams, change this setting to Narrow if you are using the optional Cut Sheet Feeder on the wide model ML491 printer. Diagnostic Test, Default = No Appears only when the optional Serial Interface is installed. Select yes to perform a diagnostic test of the serial interface. DSR Signal, Default = Valid Appears only when the optional Serial Interface is installed. Used with the Ready/Busy protocol (factory default) to select the way your system handles the DSR signal. 36 Microline 490/491 User's Guide