Oki ML8810 ML8810/8810n Setup Guide - Page 8
Continuous Forms Specifications - manual
View all Oki ML8810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Load Individual Sheets/Forms 1. Pull out the sheet supports (1) and move the sheet guide (2) to the right as far as it will go (the travel of the sheet guide is limited). Sheet_G uide_cro p.jpg 2. Place a letter size or larger sheet/form on the platform anywhere within the "Paper range when Auto Align is ON" area Continuous Forms ("FRONT") Continuous Forms Specifications • Width - Minimum: 4" (102 mm) - Maximum: 16" (406 mm) • Single Thickness Forms - Weight range: 14 to 34 lb. US Bond (52.6 to 128 g/m2) • Multi-part Forms: Front Feed Tractor - up to 8-part forms (original + 7) - Maximum Thickness: 0.0189" (0.48 mm) • Multi-part Forms: Optional Rear Feed Tractor - up to 6-part forms (original + 5) - Maximum Thickness: 0.0142" (0.36 mm) Set the Printer for Continuous Forms F5-11a.jpg 8810_3_Crop.jpg The sheet loads in to the print position, automatically aligning so that it is square with the print path. 1. If there is a sheet loaded on the platform, remove it. 2. With the printer turned on, press SEL to place the printer off line. 3. Press MODE once or twice until you see FRONT on the second line of the display. The printer changes paths and returns to the on line state. FRONT appears on the second line of the display. Note To switch back to single sheet feed, follow the same steps, pressing MODE several times until you see MANUAL on the second line of the display. 8