Oki MPS4700mb MPS4700mb Safety/Warranty/Regulatory Guide - Page 7

To comply with this law, you must enter the following information in your fax unit: • Date and time: see "Changing the Date and Time" under Setting Your Terminal in the User's Guide for instructions on doing this. Name and telephone number which identify the source of your fax transmission: see Your fax number/ your name under Setting Your Terminal in the User's Guide for instructions on doing this. FCC Radio Frequency Interference Statement WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Plug the unit into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/television technician for help. Note: It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. Changes or modifications not expressly approved by Oki Data may void your authority to operate this device. FCC Radio Frequency Interference Statement when the FDI option is installed WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Note: It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. Changes or modifications not expressly approved by Oki Data may void your authority to operate this device. California Requirement Perchlorate Warning Applicable to Lithium Batteries Sold and/or Distributed in California Perchlorate Material: special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. Industry Canada (IC) Radio Interference Statements This Oki Data apparatus complies with the Class B limits for radio interference as specified in the IC Radio Interference Regulations. With FDI option installed. This Oki Data apparatus complies with the Class A limits for radio interference as specified in the IC Radio Interference Regulations. Industry Canada (IC) Requirements for End Users This product meets the applicable Industry Canada technical specifications. The Ringer Equivalence Number is an indication of the maximum number of devices allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed five. European Union Council of the European Communities Statements of Conformance for 220/240-Volt Models Electromagnetic Conformance This product complies with the requirements of the Council Directive 89/336/EEC on the approximation of the laws of the member states relating to electromagnetic compatibility. Safety Conformance This product is in conformity with Directive 73/23/EEC on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits. 7 - English