Oki MPS5502mb MB760/MB770/MB770f/MB770fx/MPS5502mb/MPS5502mbf/MPS5502mbfx Safe - Page 7

Regulatory Information ENERGY STAR® As an ENERGY STAR Partner, Oki Data has determined that this product meets the ENERGY STAR guidelines for energy efficiency. Federal Communications Commission (FCC) Declaration of Conformity Product Name MB760, 120V MB770, 120V MPS5502mb, 120V MB770f, 120V MB770fx, 120V MPS5502mbf, 120V MPS5502mbfx, 120V MB760, 230V MB770, 230V MPS5502mb, 230V MB770f, 230V MB770fx, 230V MPS5502mbf, 230V MPS5502mbfx, 230V Model Name N22400A N22400A N22400A N22401A N22401A N22401A N22401A N22400B N22400B N22400B N22401B N22401B N22401B N22401B 1. Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2. Responsible Party Oki Data Americas, Inc. 2000 Bishops Gate Boulevard Mt. Laurel, NJ 08054-4620 1-800-654-3282 (1-800-OKI-DATA) FCC Radio Frequency Interference Statement WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Note: It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. Changes or modifications not expressly approved by Oki Data may void your authority to operate this device. FCC Administrative Council for Terminal Attachment Requirements for End Users This device has been granted a registration number by the Administrative Council for Terminal Attachment (ACTA), under Part 68 and ACTA rules and regulations for direct connection to the telephone lines. In order to comply with these FCC rules, the following instructions must be carefully read and applicable portions followed completely. 1. This equipment complies with Part 68 of FCC rules and the requirements adopted by the ACTA. On the back of the equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this inf 2. The following USOC jacks may be used with this equipment: RJ11C. 3. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation instructions for details. 4. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the local telephone company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label. 5. If the equipment, MB760/MB770/MB770f/MB770fx/ MPS5502mb/MPS5502mbf/MPS5502mbfx, causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. 6. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications to maintain uninterrupted service. 7. If trouble is experienced with this equipment (MB760/ MB770/MB770f/MB770fx/MPS5502mb/MPS5502mbf/ MPS5502mbfx), please contact the following for repair and/or warranty information: Oki Data Americas, Inc. 2000 Bishops Gate Blvd. Mount Laurel, N.J. 08054-4620 Telephone:(856) 235-2600 or (800)-OKIDATA (800-654-3282) 7 - English