Oki OKIPAGE14e English: OKIPAGE 14 Series Warranty Booklet - Page 6

Federal Communications Commission (FCC) Declaration of Conformity for 120 Volt Models 1. Product Identification OKIPAGE 14e, model EN2909D OKIPAGE 14ex, model EN2909A OKIPAGE 14i/in, model EN2908A 2. Statement This device complies with Part 15 Class B of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3. Responsible Party Oki Data Americas, Inc. 2000 Bishops Gate Boulevard Mt. Laurel, NJ 08054-4620 1-800-654-3282 (1-800-OKI-DATA) FCC RFI Statement for 230/240-Volt Models WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. Changes or modifications not expressly approved by Oki Data may void your authority to operate this device. FCC Radio Frequency Interference (RFI)Statement for 120-Volt Models This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Industry Canada Radio Interference Statement for 120-Volt Models This apparatus complies with the Class "B" limits for radio interference as specified in the Industry Canada Radio Interference Regulations. Industry Canada Radio Interference Statement for 230/240-Volt Models This apparatus complies with the Class "A" limits for radio interference as specified in the Industry Canada Radio Interference Regulations. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. Changes or modifications not expressly approved by Oki Data may void your authority to operate this device. European Union Council of the European Communities Statement of Electromagnetic Conformance for 230/240-Volt Models This product complies with the requirements of the Council Directive 89/336/EEC on the approximation of the laws of the member states relating to electromagnetic compatibility. Statement of Safety Conformance for 230/240-Volt Models This product is in conformity with Directive 73/23/EEC on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits. 6