Oki OKIPOS 441 ParallelBlack Users Guide - Page 43
DIP switch
![]() |
View all Oki OKIPOS 441 ParallelBlack manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
n DIP switch SW No. 1-1 1-2 1-3 1-4 1-5 1-6 1-7 1-8 Function Always ON Auto Cutter *1 Always ON Command emulation USB mode *2 2 colors printing Reserved Print head model *3 ON OFF Should be set on Invalid Valid Should be set on Star ESC/POS Printer class Vendor class Valid Invalid 18 pin wire 9 pin wire *1 The factory settings for enabling/disabling the auto cutter are as follows. Models without auto cutter: Invalid (Switch 1-2 = on) Models with auto cutter: Valid (Switch 1-2 = off) Note: Do not enable the auto cutter for models without the auto cutter (i.e., models with a tear bar). A mechanical error will occur. *2 USB interface model only *3 Do not change the default setting (Switch 1-8 = off). - 39 -
![](/manual_guide/products/oki-data-okipos-441-parallelblack-users-guide-4146822/43.png)
– ³¶ –
n
DIP switch
SW No.
Function
ON
OFF
±-±
Always ON
Should be set on
±-²
Auto Cutter *±
Invalid
Valid
±-³
Always ON
Should be set on
±-4
Command emulation
Star
ESC/POS
±-5
USB mode *²
Printer class
Vendor class
±-6
² colors printing
Valid
Invalid
±-´
Reserved
±-µ
Print head model *³
±µ pin wire
¶ pin wire
*±
The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch ±-² = on)
Models with auto cutter: Valid (Switch ±-² = off)
Note:
Do not enable the auto cutter for models without the auto cutter (i.e., models with a
tear bar). A mechanical error will occur.
*²
USB interface model only
*³
Do not change the default setting (Switch ±-µ = off).