Olympus 141970 LS-10 Instructions (English) - Page 19
About Recording, Before Recording
![]() |
View all Olympus 141970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
About Recording Before Recording Getting Ready Affix the windscreen: Start recording after attach the windscreen (included within) to the microphone. The noise may occur even if a windscreen is attached when forcing wind blows against a microphone. Select the media for recording: The built-in flash memory as well as an SD Card can be used (☞ P.14, P.34, P.39). Select the recording format: 2 Recording can be performed through the linear PCM format, as well as the WAV, MP3 and WMA formats (☞ P.34, P.36). About Recording Turn the Microphone Toward the Original Sound Source Turn the built-in stereo microphone in the direction that you would like to record. Placing the built-in stereo microphone over the display is the proper position for performing stereo recording. If it is below the display when recording then proper stereo recording cannot be performed because the position of the original sound will be recorded in reverse phase. About the built-in stereo microphone: Original sound source The direction of capturing sound by the microphone can be changed with the MIC SENSE HIGH/LOW switch (☞ P.24). MIC SENSE HIGH When recording with the built-in microphone: Turn the microphone in the direction of the source to be recorded. MIC SENSE LOW L R Key map On mounting: Accurate adjustments of the microphone's angle and the like can be made when the device is affixed to a commercially available tripod used for cameras. 19
![](/manual_guide/products/olympus-ls10-ls10-instructions-english-32be957/19.png)