Olympus Stylus 790 SW Stylus 790 SW Instruction Manual (English) - Page 52

Getting to know your camera better Getting to know your camera better Shooting tips and information Tips before you start taking pictures The camera does not turn on even when a battery is loaded The battery is not fully charged • Charge the battery with the charger. The battery is temporarily unable to function because of the cold • Battery performance declines in low temperatures, and the charge may not be sufficient to turn on the camera. Remove the battery and warm it by putting it in your pocket for a while. Cannot use the card • If the card's contact area is dirty, the [CARD SETUP] screen may display without reading the card. In this case, select [xD CARD CLEAN], and press o. Then, remove the card and wipe the contact area with a soft, dry cloth. No picture is taken when the shutter button is pressed The camera is in sleep mode • To save battery power, the camera automatically goes into sleep mode and the monitor turns off if there is no operation after 3 minutes when the camera is turned on (when the lens cover is open and the monitor is on). No picture is taken even if the shutter button is fully pressed in this mode. Operate the zoom button or other buttons to restore the camera from sleep mode before taking a picture. If the camera is left for 15 minutes, it automatically turns off (the lens cover closes and the monitor turns off). Press o to turn the camera on. The mode dial is set to q or P • This is the playback mode for displaying pictures on the monitor. Set the mode dial to a shooting mode. The mode dial is in the position of g • No pictures can be taken when the shooting guide is being displayed. Take pictures after selecting your desired shooting effect in the shooting guide or set it to a setting other than g in shooting mode. The flash is charging • Wait until the # (flash charge) mark stops blinking before taking the picture. The memory gauge is full • No pictures can be taken when the memory gauge is full. Wait until there is space in the memory gauge. a Shoot Before taking any pictures (Off) b After taking one picture (Lit) Shoot c Shoot Wait After taking several pictures (Lit) d Maximum reached (All lit) The date and time have not been set The camera has been used in the same conditions from the time of purchase • No date and time have been set for the camera at the time of purchase. Set the date and 52 EN time before using the camera. g "Turn the camera on" (P. 6) "X Setting the date and time" (P. 35)