Onkyo A-9030 User Manual English - Page 27
Onkyo Dock, External Components, Remote Controller, interlock does not function
View all Onkyo A-9030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Onkyo Dock There's no sound. • Make sure that the Onkyo Dock is connected to the integrated amplifier properly. • Make sure that no video content is being played. • Reset the iPod. Other • When the Auto Standby (ASb) function is activated, the power of the Onkyo Dock connected via V is automatically turned off (➔ page 25). Can't control properly by using the remote controller. • Make sure that the V cable is connected to the integrated amplifier correctly. Check that each device is connected correctly and that the RI MODE switch is set correctly (➔ page 17). External Components No sound is heard from a connected component. • Make sure the correct input source is selected (➔ page 23). • Make sure the analog audio cable is connected correctly (➔ page 14). When the V interlock does not function properly • Check that each device is connected correctly and that the RI MODE switch is set correctly (➔ pages 15 to 17). • Check that the switch on the back of the integrated amplifier is set to the correct setting. • The settings are not enabled when the switch is changed during the Standby mode. To change a setting, be sure to turn on the unit prior to making any changes. • The connecting method may vary depending on the device that will be connected. Please refer to the V connection section in the owner's manual of the connected device. The sound from turntable is distorted. • If your turntable has a built-in phono preamp, connect to other analog inputs such as LINE IN. • If your turntable does not have a built-in phono preamp, connect a turntable to PHONO (➔ page 19). • Make sure that the ground wire is connected. Otherwise, it may produce an audible hum and noise. Remote Controller The remote controller doesn't work properly. • Make sure the batteries have been installed with the correct polarity (+/-) (➔ page 7). • Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.) • The remote controller is too far away from the integrated amplifier, or there's an obstacle between them (➔ page 7). • The integrated amplifier's remote control sensor is being subjected to bright light (inverter-type fluorescent light or sunlight). • The integrated amplifier is located behind the glass doors of an audio rack or cabinet. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. The integrated amplifier contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this should happen, unplug the power cord, wait at least 5 seconds, and then plug it again. Before disconnecting the power cord from the wall outlet, set the integrated amplifier to Standby. If during idling the cover is too hot to touch, then ventilation needs to be improved. En 27