Onkyo CS-1045 R-1045 User Manual English - Page 55

Setting the Clock Setting AccuClock Using a Specific Station RDS is only available in areas where RDS broadcasts are available. The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock cannot be set properly using that station, you can specify the FM station the which AccuClock function uses. This must be an FM station that supports RDS CT (Clock Time) information. 1 Press the [TIMER] button. "Clock" appears on the display. If the clock has already been set, a timer option appears instead, in which case you'll need to press the [TIMER] button repeatedly until "Clock" appears. 2 Press [ ]. "AccuClock" appears on the display. If "ManualAdjust" appears, use the Previous and Next [ ]/[ ] buttons to select "AccuClock" or "*AccuClock*". 3 Press [ ]. The frequency flashes on the display. 4 Use the Fast Reverse and Fast Forward [ ]/[ ] buttons to tune into the FM station. Tip: The RDS indicator appears when tuned into a station that supports RDS. The RDS indicator will flash while the stereo receiver searches for a station and light up continuously when a station is found. 5 When you've selected the station, press [ ]. While the clock is being set, "Wait" flashes on the display. It may take a few minutes to set the clock. When the clock has been set, the message "Clock Adjusted" scrolls across the display, then the day and time are displayed for a while. Notes • If the clock is not set correctly, specify another FM station and try again or set the clock manually (see page 56). • The AccuClock function automatically updates the clock every day. If you don't want it to, you can turn off the AccuClock function (see page 23). 55